Descargar Imprimir esta página

Publicidad

Troubleshooting

Q1.
I correctly typed in the print server name and printer name, but I still cannot add a network
printer. What should I do?
A1.
Double check your hardware connections; make sure that the print server and printer are
powered ON and are properly connected. Also verify that the spelling of the server name and
printer name are correct.
Q2.
I verified that the hardware installation is correct and that the print server name and printer
name are correct, but I still cannot find the network printer. What should I do?
A2.
Make sure that the print server name and printer name are entered correctly. There should be
no spaces, and the back slashes that separate the print server name and printer name should be
this, \\, instead of this, //.
Q3.
I successfully added a network printer to my computer and I can print a test page, but I cannot
print anything from Microsoft Word or other applications.
A3.
Make sure to set the newly installed network printer as your default printer. Click Start and
then click Printers & Faxes, verify that your printer icon has a check on it.
Q4.
I configured my print server to automatically receive an IP Address from a DHCP server, and
now I cannot go into the print server's web utility.
A4.
Open PS-Utility v3.00 (See 3. Configure the Print Server) to locate your print server's IP
Address. For Mac users, press the Reset button at the back of the TEW-P1UG, hold the button for
15 seconds, release the button, and enter
utility features.
Q5.
After I successfully configured the TEW-P1UG to match my wireless network settings, I can
not print through the Print Server.
A5.
First, verify that the wireless settings match your wireless network settings. Second, verify that
the antenna is attached to the Print Server and the WLAN LED on the Print Server is lit.
If you still encounter problems or have any questions regarding the TEW-P1UG, please refer to the User's
Guide included on the Utility CD-ROM or contact TRENDnet's Technical Support Department.
Certifications
This equipment has been tested and found to comply with FCC and CE Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received.
Including interference that may cause undesired operation.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV
INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS
EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER'S AUTHORITY TO
OPERATE THE EQUIPMENT.
http://192.168.0.1
in a web browser to access the web
Waste electrical and electronic products
must not be disposed of with household
waste. Please recycle where facilities
exist. Check with you Local Authority or
Retailer for recycling advice.
8

Publicidad

loading