Transmitter Components - Phonic SAFARI 3000 Manual Del Usuario

Manual Scan
1. Power-on the Safari One-touch Autoscan wireless receiver
(WR-1) and the microphone transmitter (WM-1 or WB-1).
2. Push the Scan button on the WR-1 for 2 seconds. The numeric
LEDs on the WR-1 will begin to blink. To manually select fre-
quency, continue to click the Scan button until you reach the
desired channel.

Transmitter Components

Beltpack
Antenna
Power Status
UHF
WB-1
lavalier
UHF
WB-1
Safari 3000
Power Switch
Headset / lavalier mic jack
Infrared
3. Hold the WM-1 / WB-1 close against the receiver and push
the Lock button to confirm the channel and establish the link
between the microphone transmitter and receiver. At this point,
the RF LEDs will activate and the AF LEDs will respond to the
microphone signal. If the connection is not established, reat-
tempt the manual or autoscan process.
Handheld Microphone
Battery Compartment
Headset
UHF
UHF
WB-1
WB-1
Power Switch
5