Festool UG-KAPEX Instrucciones De Montaje página 10

GB
UG-KAPEX
connecting elements are tightened se-
curely. The retaining rails on the power
tool must always be locked firmly in posi-
tion. Loose connections can cause instabil-
ity and result in inaccurate cutting.
– Only install and remove the power tool
in transport position (see description
in the operating instructions accom-
panying your compound mitre saw).
Otherwise the centre of gravity of the pow-
er tool may prevent you from holding the
machine safely.
– Make sure that long and heavy work-
pieces do not disrupt the equilibrium
of the base frame. Always support the
free end of all long, heavy workpieces.
– Do not lift or transport the appliance by the
handle using a crane or lifting gear.
6 Assembly
6.1 Base frame UG-KAPEX
X
Move the compound mitre saw to trans-
port position [2]
operating instructions accompanying your
compound mitre saw).
X Attach the retaining rails [3].
X
Attach the folding/fixed stirrup to the
compound mitre saw with retaining rails
and secure [4 +5].
X
Place the compound mitre saw with re-
taining rails on the base frame and secure
[6 +7].
X
Insert the folding/fixed stirrup in the base
frame [8].
6.2 Trimming attachment KA-UG
L Illustrations for the left trimming attach-
ment - the right trimming attachment is
fitted in the same way.
X Fold down the support foot [9].
X
Place the trimming attachment in the
groove, secure the lugs [10].
7 Settings
Adjust the following settings before using for
the first time:
X
Loosen the lugs and hexagon screws on
the trimming attachment [11].
X Adjust the attachment horizontally [12].
X
Align to the correct position [13].
X Adjust the scale [14].
10
(see description in the
X
Secure the lugs and hexagon screws [15].
8 Working with the machine
Observe the following instructions:
– Do not overload the base frame. Observe
the maximum load capacity.
– Make sure that the all bayonet fittings are
closed before starting work.
– Always clamp the workpiece securely, es-
pecially long, heavy sections. After the ma-
chine has cut all the way through the
workpiece, the centre of gravity may shift
suddenly and cause the base frame to tip
over.
X
Open the telescopic extension [16].
L Storage over long period: set down the
UG-KAPEX with KAPEX as shown in Fig.
[21].
9 Transport
X
Move the compound mitre saw to trans-
port position [2]
operating instructions accompanying your
compound mitre saw).
X
Detach the folding/fixed stirrup and fold in
the saw [17].
X Lock in position [18].
L If you purchase both trimming attach-
ments in a set, you can stow these in the
transport pouch
[20].
L The base frame can be transported in a
vertical [20] or horizontal
10 Accessories
Use only original Festool accessories and
Festool consumable material intended for
this machine because these components are
designed specifically for the machine. Using
accessories and consumable material from
other suppliers will most likely affect the
quality of your working results and limit any
warranty claims. Machine wear or your own
personal workload may increase depending
on the application. Protect yourself and your
machine, and preserve your warranty claims
by always using original Festool accessories
and Festool consumable material!
The order numbers of the accessories and
tools can be found in the Festool catalogue or
on the Internet under "www.festool.com".
(see description in the
[19] on the base frame
[21] position.