Publicidad
7, INITIALIZATION
Adjustments when Replacing Parts (Initialization)
The following adjustments should always be performed after replacing the
Game PC Board, ROM, or Control Potentiometers.
The game will not operate correctly if these adjustments are not made.
Note:
After initialization perform "SWITCH TEST"
and make sure "RIGHT OK" and "LEFT OK" is displayed when the handle
bar is turned fully right and left.
1.
Slide the TEST switch ON while pressing the SERVICE Switch. The
following screen is displayed.
(a) GO TO [SWITCH TEST]
You can jump to switch test by just pressing the ENTER button.
2.
Ensure that the handle bar is central.
3.
Press the SERVICE switch to update the setting.
4.
Select GO TO [SWITCH TEST].
5.
Turn the handle bar fully right and left and check that "RIGHT OK" and
"LEFT OK" is displayed. If "RIGHT OK" and "LEFT OK" is not displayed
check the bike potentiometer and re-initialize.
6.
Slide the TEST Switch OFF to return to normal game mode.
I/F INITIALIZE
0000
GO TO [SWITCH TEST]
KEEP HANDLEBAR CENTER
AND PUSH SERVICE TO STORE
RESULT
Page 56
(see section 6-3-3-3 page 51)
Publicidad
