Compressor Assembly; Replacing The Bike Swing Potentiometer - NAMCO MOTOCROSS GO! Deluxe Manual Del Operador

8-1 Compressor Assembly

NOTE:
There are no user serviceable parts on the compressor
Under no circumstances should any regulator valve be adjusted.
Altering the regulator valves could lead to serious damage.

8-2 Replacing the Bike Swing Potentiometer

1. Remove 4off Security screw (M5x12) and remove the front bearing cover.
2. Disconnect the connector.
3. Loosen the grub screw (M4x10) and remove the potentiometer complete
with the mounting bracket.
4. Replace the potentiometer taking care to connect the correct wires to the
terminals.
5. Reassemble in reverse order.
6. Re-initialize the game.
Note: When refitting the potentiometer ensure that the tab on the
potentiometer engages with the hole in the mounting bracket, and that
the grub screw engages on the flat of the potentiometer shaft.
After re-assembly, ensure that the game is re-initialized before
normal game play.
(see section 7 page 54)
(see section 7 page 54)
Page 57
assembly.