Glacier bay PPMELCHT18 Guía De Uso Y Cuidado

TOOLS REQUIRED
Claw hammer Safety goggles
Measuring tape Wall hardware
Installation
1
PREPARING FOR INSTALLATION
NOTE: Before installation, make sure all parts are present.
Compare parts with the Hardware Included list. If any part is
missing or damaged, do not attempt to install the product.
□ Determine the desired mounting location, and mark the
wall where the unit will be installed.
NOTE: For secure installation, the unit must be mounted
to at least one wall stud.
3
INSTALLING THE CABINET
□ For wall stud installation, insert #12 x 3 in. screws with washers into the stud locations (not included).
□ For drywall installation, drill holes at the appropriate locations and insert toggle bolts with washers
(not included).
□ For concrete wall installation, drill 1/4 in. holes at the appropriate locations and insert #12 wall anchors,
followed by #12 x 3 in. screws (not included).
4
INSTALLING THE VANITY TOP
IMPORTANT: Do not use plumber's putty.
NOTE: The faucet, drain, and supply lines are not included. Install these
parts to the vanity top according to the manufacturer's instructions.
□ Apply silicone caulk/sealant (not included) to all four corners of the cabinet.
□ Place the vanity top onto the cabinet.
□ Position the top so that it has an equal amount of overhang on each side and use a level to
ensure the vanity top surface is level.
□ Apply silicone onto the seam between the edge of the vanity top and the wall, smooth the
bead, and allow to cure before use.
Phillips screwdriver
Caulk/sealant
Use and Care Guide
Power drill
Level
2
POSITIONING THE CABINET
□ Move the cabinet into place, and use wood
shims to level the cabinet against the wall.
1000 959 159
Item #
1000 877 814
Item #
1000 013 647
Item #
PPMELCHT18
Model #
PPMELCHT24
Model #
PPMDACO24
Model #
Vanity Combo
HARDWARE INCLUDED
AA - Knob BB - Knob Screw
18" x 1
24" x 2
HOMEDEPOT.COM
Please contact 1-888-774-8062 for further assistance.
x 1
x 2