Hitachi DH 14DSL Manual De Instrucciones página 15

Martillo perforador a bateria
Ocultar thumbs Ver también para DH 14DSL:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

(3) Pushing the rotary hammer forcibly is not necessary
at all. Pushing slightly so that drill dust comes out
gradually is just sufficient.
CAUTION:
When the drill bit touches construction iron bar,
the bit will stop immediately and the rotary
hammer will react to revolve. Therefore please grip
the side handle and handle tightly as shown in
Fig. 11.
3.
Rotation only
Turn the change lever fully in the direction of the
" " mark to set "rotation only". (Fig. 10)
To drill a wood or metal material using the optional
drill chuck and chuck adapter, proceed as follows.
Installing drill chuck and chuck adapter : (Fig. 12)
(1) Attach the drill chuck to the chuck adaptor.
(2) The part of the SDS-plus shank is the same as the
drill bit. Therefore, refer to the item of "Mounting
the drill bit" for attaching it.
Front
Drill chuck
cap
Chuck adapter
Part of SDS-plus shank
CAUTION:
Application of force more than necessary will not
only expedite work at all, but will deteriorate the
tip edge of the drill bit and reduce the service life
of the rotary hammer in addition.
Drill bit may snap off while withdrawing the rotary
hammer from the drilled hole. For withdrawing,
it is important to use a pushing motion.
Do not attempt to use the rotary hammer in the
rotation and striking mode with the drill chuck and
chuck adapter attached. This would seriously
shorten the service life of every component of the
machine.
4.
When driving wood screws (Fig. 13)
(1) Selecting a suitable driver bit
Employ plus-head screws, if possible, since the
driver bit easily slips off the heads of slotted-head
screws.
(2) Tightening wood screws
Prior to tightening wood screws, make pilot holes
suitable for them in the wooden board. Apply the
bit to the screw head grooves and gently drive the
screws in the holes.
Grip
Fig. 12
Bit
Socket
Chuck adapter
CAUTION:
Exercise care in preparing a pilot hole suitable for
the wood screw taking the hardness of the wood
into consideration. Should the hole be excessively
small or shallow, requiring much power to drive
the screw into it, the thread of the wood screw
may sometimes be damaged.
5.
Using depth gauge (Fig. 14)
(1) Loosen the knob on the side handle, and insert the
depth gauge into the mounting hole on the side
handle.
(2) Adjust the depth gauge position according to the
depth of the hole and tighten the knob bolt securely.
Mounting hole
Side handle
6.
How to use the drill bit (taper shank) and the taper
shank adapter
(1) Mount the taper shank adapter to the rotary
hammer. (Fig. 15)
(2) Mount the drill bit (taper shank) to the taper shank
adapter. (Fig. 15)
(3) Turn the switch ON, and drill a hole to prescribed
depth.
(4) To remove the drill bit (taper shank), insert the
cotter into the slot of the taper shank adapter and
strike the head of the cotter with a hammer
supporting on the rest. (Fig. 16)
English
Front cap
Grip
Fig. 13
Depth gauge
Fig. 14
15

Publicidad

Tabla de contenido
loading

Tabla de contenido