Delete Users
Programming Step
1. Enter Program Mode:
2. Delete user
OR
Delete Card
OR
Delete all users
3. Exit:
Set Access Mode
Programming Step
1. Enter Program Mode:
2. PIN Access
OR
PIN + Card Access
OR
PIN or Card or fingerprint Access
3. Exit:
Set Safety Mode
In safety mode, it can be set to deny access for 10 minutes after 10 failed PIN/card attempts in
10 minutes
(Factory default is OFF).
Programming Step
1. Enter Program Mode:
2. Strike-Out OFF
OR
Strike-Out ON
3. Exit:
Set Buzzer
Programming Step
1. Enter Program Mode:
2. Buzzer OFF
OR
Buzzer ON
3. Exit:
Keystroke Combination
* (Master Code) #
2 (User ID) #
The users can be deleted continuously.
2 (Read Card) #
2 (Master Code) #
*
Keystroke Combination
* (Master Code) #
3 0 #
3 1 #
3 2 # (factory default)
*
Keystroke Combination
* (Master Code) #
6 0 # (factory default)
6 1 #
*
Keystroke Combination
* (Master Code) #
7 0 #
7 1 # (factory default)
*