eTIGER ES-DL02 Manual Del Usuario página 7

INTRODUCTION
Method 1: Stick by 3M stickers
The device packed with 3M double-side stickers, can easily stick the Wireless Keypad and
Wireless Lock on smooth surface (We used high-quality 3M stickers, the stickiness will be the
best after sticking in 24 hours).
Below introduction for how to install Wireless Lock intensively:
Attentions of installing the Hasp
Confirm the direction and position of Hasp, meanwhile, make sure the Hasp align the
doorframe.
(So please make sure the direction of Hasp is fit for main body of lock before installation.)
Installing the Hasp
Put the Locating Rings into Hasp, and stick the 3M sticker at the back side of Hasp (You can
screw the hasp on the Reinforcing Plate if needed, then stick 3M sticker at the back of plate. It
can increase the stick area to make the Hasp stronger).
Installing the main body of lock
Fix the main body of lock and the Fixed Plate by M5*6 hex screws in the packaging, and stick the
3M sticker on the back of Fixed Plate.