eTIGER ES-DL02 Manual Del Usuario página 12

OTHERS
Users Operation
Programming Step
PIN User Access
Card User Access
Fingerprint Access
PIN + Card User Access
By Remote Transmitter
How to Open & Close the lock when the user is inside the door?
Programming Step
Open the lock
Close the lock
By Remote Transmitter
Lock Immediately
The Wireless Lock will be locked automatically around 5 seconds after we open it. If we want to
lock it faster, please press "0 #" on the Keypad, or press
on the wireless lock, it will lock immediately.
CLOSE
Pair Wireless Keypad / Remote Transmitter with Wireless Lock
(They are already paired when out of factory, if no problem, the users do not need to do this
operation in using.)
Note: 1. The Wireless Lock can pair 16 parts (Keypad + Remote Transmitter) maximum.
2. When pairing, all parts must be paired, then exit paring mode. If need adding one more
part, you still need to pair all parts again.
Step 1: Enter pairing mode
Open the battery cover of Wireless Lock, press the small round button left of battery with a
slender rod, hold it for 2 seconds until hearing two beeps, that means in the pairing status.
Step 2: Pairing Wireless Keypad
Press the button "0 #" on the keypad, hold it for 2 seconds until hearing two beeps from Lock,
that means pairing successfully.
Step 3: Pairing Remote Transmitter
Press any button on the Remote Transmitter, hold it until hearing two beeps from Lock, that
means pairing successfully.
Step 4: Exit pairing mode
After pairing all parts, press the small round button in the Wireless Lock again, hold it until
hearing two beeps, that means exit pairing successfully.
Keystroke Combination
(PIN) #
(Read Card)
(Read Fingerprint)
(Read Card) (PIN) #
Press
Keystroke Combination
Touch on the lock
OPEN
Touch on the lock
CLOSE
Press
on the Remote Transmitter, or touch