Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Your p ressure washer requires some assembly andisready
foruse onlyafter i thasbeen properly serviced withthe
recommended
oiland fuek
_f
you have any problemswith the assembly of yeur
pressurewasher, pJeasecaJJ th8 pressurewasher heJpJiNe
at 1-800-222-3136.
UNPACK THEPRESSURE WASHER
1.
Remove everything from carton except pressure washer.
2.
Open carton completely by cutting each corner from top
to bottom.
3.
Remove pressure washer from carton.
CARTON CONTENTS
Check all contents, if any parts are missing or damaged, call
the pressure washer helpline at 1o800o222o3136.
*
Main Unit
*
Handle
*
Accessory Tray with Hose Wrap
*
High Pressure Hose
*
Spray Gun
*
Nozzle Extensionwith Quick Connect Fitting
*
Oil Pouch
*
Bottle Bracket Wireform
*
PerfectMix
TM
Siphoning Unit/Hose
*
Parts Bag (which includes the following/:
*
Operator's Manual
*
Owner's Registration Card
*
Rubber Straps (2)
*
Bag containing 3 Multi-Colored Quick Connect Spray
Tips
*
Handle FasteningHardware Kit twhich includes}:
*
Handle Bolts (2)
°
Carriage Bolt (1)
,
Plastic Knobs for Handle(21
,
Plastic Knob (1)
,
Tree Clips (4)
Become familiar with each piece before assembling the
pressure washer, identify all contents with the illustration on
page 6. if any parts are missing or damaged, call the
pressure washer helpline at 1o800o222o3136
ASSEMBLING PRESSURE WASHER
Your Craftsman pressure washer will need assembly before
operation:
1.
Fill out and send in registration card.
2.
Attach handle and accessorytray.
3.
Add oil to engine crankcase.
4.
Add fuel to fuel tank.
5.
Connect pressure hose to spray gun and pump.
6.
Connect water supplyto pump.
7.
Attach nozzleextension to spray gun.
8.
Select/attach quick connect spray tip to nozzle extension.
Attach Handte and Accessory Tray
1.
Place handle (A) onto handle supports connected to
main uniL Make sure holes in handle align with hobs on
handle supports.
2.
insert handle carriage bolts (B) through hobs from
inside of unit and attach a plastic knob (C) from outside
of uniL Tighten by hand.
NOTICE By loosening both knobs to the middle section of
the attachment bolt. the upper handle can fold forward to
store fiat atop the cold engine. DO NOTfold the handle down
while the engine is hot.
3.
insert rubber straps (D) through slots (E) in back of
accessorytray and pull tight from fronL
4.
Placeaccessory tray (F) over hobs (G) on handle
(viewing from front of unit). Push the tree clips (H) into
the hobs until they sit fiat against the accessory tray.
5.
insert multi-colored quick connect spray tips and other
supplied accessories in spaces provided in accessory
tray. See How to Use Accessory Tray,
Publicidad
Tabla de contenido
