LG LP1013WNR El Manual Del Propietario página 10

H O W T O U S E
CONTROL PANEL AND REMOTE
4 3
Operation of functions is the same when using the remote
or the control panel, unless otherwise stated.
NOTE:
The remote sensor is located under the LED display.
Point the remote anywhere at the sensor. The remote may
not work if the sensor is in bright light or if there is not a
clear path between the remote and the sensor.
/
5 (TEMP/TIMER)
In COOL and DRY modes, the
adjust the set temperature up to 86°F or down to
60°F, in one degree increments. The temperature
can be switched between degrees Fahrenheit and
degrees Celsius, pressing
button at the same time, or pressing °F /°C button
on the remote.
When the TIMER function is selected, use the
buttons to adjust the delay time from 1 to
24 hours, in one hour increments.
If you press and hold the
temperature or time will change automatically after
a few seconds.
NOTE: The displayed temperature is the SET
temperature, not the room temperature. In COOL or
DRY mode, the thermostat in the air conditioner
will run the compressor until the set temperature is
reached, then cycle the compressor on and off to
maintain the set temperature.
6
LED Display
LED display shows the set temperature, fan
speed, or the selected TIMER delay.
Indicators will light to show active mode and
additional settings. The LED display will show
the FL to indicate when the internal water drain
tank needs to be emptied.
10
6
Dry
1
5 2
buttons
the button and
buttons, the set
5
3
9
7
4
7
SLEEP
Increases the temperature by 1 °F every 2 hours
to allow a more comforable adjustment for the user.
8
°C/°F(CELSIUS AND FAHRENHEIT
EXCHANGE BUTTON)
°C/°F
function can be activated only with the
remote. When the displayed temperature is
°C (or °F), you can press this button to switch to
°F (or °C).
9
CONTINUOUS
After setting continuous, the unit will keep running
no matter what temperature is selected.
Dry
2
8 8
1
1
8
1