Warning! Keep electrical appliances out
of reach from children or in firm persons.
Do not let them use the appliances
without supervision.
Features
1. On/off switch
2. Dust bowl
Fig. A
3. Crevice tool
4. Wet pick-up accessory
Installation
Fitting the charging base to the
wall (Fig. C1 & C2)
The charging base can be placed on a
worktop or fitted to the wall to provide a
convenient storage and charging point
for the appliance.
Assembly
Fitting the accessories (Fig. A & D)
The appliance is supplied with the
following accessories:
a crevice tool (3) for confined spaces
◆
a wet pick-up accessory (4) for wet
◆
spills
To fit an accessory, proceed as follows:
Take the accessories from the
◆
appliance.
Insert the appropriate accessory into
◆
the front of the appliance.
You may refit the other accessory by
clicking it into the accessory holder.
To refit both accessories:
Push the accessories down until they
◆
click into place.
ENGLISH
Use
The appliance can be charged while
◆
placed on a worktop or hung on the
wall using the wall hook provided.
Before first use, the battery must be
◆
charged for at least 16 hours.
Do not leave the appliance connected to
◆
the charger for more than 48 consecutive
hours.
Charging the battery (Fig.B)
Make sure that the appliance is
◆
switched off. The battery will not be
charged with the on/off switch in the
on position.
Fit the appliance properly on the
◆
charger aligning the arrow on the
charger with the split of the appliance.
Plug in the charger. Switch on at the
◆
mains.
Leave the appliance to charge for at
◆
least 16 hours.
For a better battery life, it is recommended
◆
to fully run the battery down and recharge
it at least once a month.
While charging, the charger may become
warm. This is normal and does not
indicate a problem.
Warning! Do not charge the battery at
ambient temperatures below 4 °C or
above 40 °C.
Switching on and off (Fig. E)
To switch on, slide the on/off switch
◆
(1) forward.
To switch off, slide the on/off switch
◆
back.
9