Introduction; Installation - Ecler NUO2.0 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

2. INTRODUCTION

Congratulations for acquiring a genuine, professional ECLER device!
The NUO2.0 is a professional DJ mixer designed and manufactured by ECLER; an enterprise with headquarters in
Barcelona, which works on professional audio equipment since 1965.
The NUO2.0 is a professional audio mixer thought for any kind of DJ, due to its wide range of functions, which
make it a console able to mix any kind of music style: techno, house, minimal, electro, hip hop, ...
The NUO2.0 is a mixer thought for scratching techniques, due to the versatility of the adjustments of faders and
crossfaders. The NUO2.0 is furthermore able to wear the ETERNAL crossfader, ECLER's magnetic crossfader with
5 years guarantee, which has been specially designed for scratching specialists.
This genuine mixer uses the best components available on the market, obtaining the highest possible sound
quality. The over 40 years of experience in the design of professional audio equipment make that the circuits are
extremely efficient and a warm and crystal clear analogue sound is obtained. All circuits are mounted and tested in
our factory site in Barcelona.
Furthermore, the NUO2.0 is a mixer which has been specially designed for all kinds of professional installations. Its
design and resistance make it an ideal console for professional installations, as well as for mobile applications
executed by the trendiest DJ's.

3. INSTALLATION

The main consideration to be taken when looking for the best setup location for the NUO2.0 has to be the
maximum commodity for the user and the easiness for realizing the necessary connections.
The NUO2.0 has been basically designed as an on desk mixer and its usual location will
be between two turntables or CD players. The mixer is 37 cm (14.57") deep and 16.5 cm
(6.5") wide.
Using the metallic side panel kit (optionally available) you may fix your NUO2.0 directly on
a support surface or on those side panels which also allow you to skew it.
Because of the high gain of the PHONO and MICRO inputs, always try to place the mixer
as far away as possible from noise sources (dimmers, engines, etc.) and mains wires. For
the very same reason, and under any circumstance, you should never remove the unit's
metallic cover.
The power consumption of the NUO2.0 is very low, so they do not need any cooling, but you should avoid extreme
temperatures and the atmosphere should be as dry and dust free as possible.
The NUO2.0 operates now with a new universal input power supply "Switching Power Supply" and can perfectly
works without any internal modification from 90V to 264V – 47 to 63Hz. Make sure that the mains-wire is far away
from the signal-cables in order to avoid any possible audio hum.
In order to protect the unit from an eventual electrical overload it carries a T 0.5A fuse. Should it ever blow up,
unplug the unit from mains and replace it with an identical one. If the new fuse blows again contact immediately
with our authorized technical service.
ATTENTION: NEVER SHORT-CIRCUIT THE SECURITY PATH NOR USE A HIGHER VALUE FUSE.
CAUTION: Fuse substitutions have to be performed by a qualified technician.
5

Publicidad

Tabla de contenido
loading

Tabla de contenido