Maintenance And Care; Servicing Guidelines - Yamabiko MTA-TC Manual De Instrucciones

Moving parts can amputate fingers or cause severe injuries. Keep hands, clothing and loose objects away from all
openings. Always stop engine, disconnect the spark plug wire, and make sure all moving parts have come to a com-
plete stop before removing obstructions, clearing debris, or servicing unit. Allow unit to cool before performing service.
Wear gloves to protect hands from sharp edges and hot surfaces.

Servicing guidelines

Component/System
Drive shaft
Gear Housing
Gear Housing/Tines
Screws, bolts and nuts
IMPORTANT
Time intervals are maximum. Actual use and your experience will determine the frequency of required maintenance.

Maintenance and care

If you have any questions or problems, please contact your dealer.
Lubrication
Maintenance Procedure
Grease
Grease
Clean
Inspect, Tighten/Replace
Maintenance and care
Maintenance and care
WARNING
Frequency
Every 25 hours of use
Every 25 hours of use
Daily or every 4 hours
Before each use
Gear housing
1. Clean all loose debris from gear housing.
2. Remove screw plug (A) and check level of grease.
3. Add grease if necessary. Do not over fill.
4. Install screw plug (A).
Drive shaft assembly
IMPORTANT
Lower and upper drive shaft must be lubricated with grease
every 25 hours of operation, otherwise drive shaft assembly
overheating and failure can result.
1. Loosen upper gear housing bolt (A) and locator screw (B).
2. Remove gear case assembly.
13