Star Progetti HELIOSA HI DESIGN 66 Serie Instrucciones De Uso página 15

HELIOSA® HI DESIGN 66 - 1500 WATTS IPX5 WATERPROOF (cod. 66BX5 - 66FMX5)
•
Revolving model with 5 m. electric cable
• For indoor and outdoor areas
•
IPX5 protection rating - Totally protected against rain and water sprays (Star Progetti Patent)
•
Accessories provided: 5 m electrical cable, schuko plug, stainless steel grid, brackets (photo a/b)
• Dimensions cm 51x16x21,5
• Net weight kg 2,10
Photo a)
3. USES
• HELIOSA® HI DESIGN 66 IPX5 is suitable for inside and outside areas.
4. TECHNICAL DATAS HELIOSA® HI DESIGN 66
*HEATED AREAS
The heated areas indicated can vary according to the installation height, the environmental conditions and the synergy produced
when several heaters installed. In the latter case results can be lower or higher.
5. INSTALLATION TO WALL
Install the heater on the wall at a minimum distance of 32 cm from the ceiling (see installation examples). The height at which the heaters
are normally installed varies from 2.5 metres to a maximum of 3,0 metres. Wall mounting is the ideal solution to achieve the best
results in terms of heat with the reflector at a 45° angle and the heater perfectly horizontal. The appliance must not be placed
immediately below a mains socket.
6. POSITIONING OF HELIOSA® HI DESIGN 66
1. Aim the HELIOSA® 66 reflector in the direction required for the wall-mounted installation. The normal angle is 45° to the horizontal
plane.
2. Never install HELIOSA® 66 an inflammable surface or facing an inflammable surface.
3. HELIOSA®66 must be placed at a clear distance (line of vision) of not less than 2.0 metres from objects such as cardboard, fabrics,
curtains and windows. If used in workshops and garages where there are inflammable paints, HELIOSA 66 must be located more than
metres from the hazard.
4. We recommend that the heater is not used in dusty non-ventilated environments to avoid damage to the bulb.
Photo b)
15