Troubleshooting - POLTI vaporella SILENCE FRIENDLY_8.85 Manual De Instrucciones

11. TROUBLESHOOTING

PROBLEM
If water comes out from the Iron
soleplate instead of steam
Steam does not come out from
the Iron soleplate
Little steam comes from the Iron
soleplate.
The appliance does not turn on.
Some water drops are present
on the fabric.
Presence of water under the
appliance.
Should the problems persist, contact an Authorised Polti Service Centre (see www.polti.com for the up-to-date list) or
Customer Services.
CAUSE
The pressure values have not been
reached
The temperature knob on the iron is
set at the minimum value.
First steam release.
ON-OFF button and boiler button
off.
Water tank is empty.
The steam regulation knob is set at
the minimum value.
The steam is dry, so is barely visible,
but is present and effective
ON/OFF switch turned off.
No power.
The cover used on the Ironing board
is wet since it cannot withstand the
power of the steam station.
Boiler cleaning cap screwed on
incorrectly.
Seal of the boiler cleaning cap
damaged.
| 24 |
SOLUTION
Check that the ready steam lamp is OFF indica-
ting that the Vaporella has reached the right
pressure
Wait until the required temperature and pres-
sure are reached as shown by the indicator
lights.
Adjust the temperature knob on the iron to the
medium/maximum vaue.
Release onto a cloth until steam comes out
from the holes on the solepate.
Make sure that the appliance is powered and
that the power ON-OFF and boiler button are
on
Fill the water tank.
Increase the steam flow by adjusting the steam
regulation knob to the medium/maximum
value.
This is normal especially in particular environ-
mental conditions.
Press the ON/OFF switch.
Check that the appliance has been disconnected
from the mains, as indicated in Section 1.
Check that the shaft is suitable (shaft with grille
that prevents condensation).
Unscrew the boiler cleaning cap and screw it back on
(Chapter 9).
Take Vaporella to an authorised service centre