Beper BT.110 Manual De Instrucciones página 9

EN
Toaster Use instructions
DESCRIPTION Fig.1
1. Slots
2. Defrost button
3. Switch lever
4. Reheat button
5. Stop/Cancel button
6. 7 levels toasting knob
7. Anti-slip foot
8. Removable crumb tray
USE
Remove all packaging and clean the appliance carefully.
Place the appliance on a stable and flat surface.
Insert pieces of bread in the sandwich slots.
Plug the cord supply into the socket.
Turn the knob to select the toasting level desired between 7 levels.
Put down the switch lever and the toaster start working, it will stop automatically when the time/level is over,
bread will rise automatically from the slots.
If bread is not enough toasted, select higher toasting level, or if it is too much toasted, select lower one. The
toasting can be stopped in any time by pressing the stop/cancel button; the sandwich will automatically rise from
the slots.
Take care while touching the bread as it will be very hot.
The toaster is equipped with 2 additional functions:
"Defrost" function
Frozen slices of bread may be toasted by pressing the defrost button immediately after lowering the lever; the
toasting cycle will be lengthened in order to achieve the desired browning. The defrost indicator light will remain
lit while the defrost function is in use.
"Reheat" function
To warm toast that has popped up but gone cold, lower the lever again and then press the 'Reheat' button.
Please note that this is fixed reheat time which cannot be adjusted by the browning control. The reheat function
can be cancelled at any time by pressing the Stop/Cancel button . The reheat indicator light will remain lit while
the reheat function is in use.
FOR BETTER TOASTING
When used for the first time, do not put bread into the toaster; that will allow to the heat resistance to pre-heat
and to eliminate the smell of "new" . To get better results, use same thickness, size and freshness piece of bread.
Do not put food that could make juice or other, in order to prevent from damages or fire and make it hard to clean.
The slide-out crumb tray must always be cleaned after each use.
To get homogeneous toasting, it is recommended to wait at least 30 seconds for toasting again.
CLEANING AND CARE OF THE TOASTER
Always unplug the cord supply from the socket before cleaning or care. Let the toaster to cool. The external part
of the toaster can be cleaned with a smooth cloth. Do not use alcohol, abrasive detergents or every detergent
that could damage the toaster. Do not immerse into water. After use, unplug the cord supply from the socket and
let the toaster to cool down before store it. If there remain embedded pieces of bread, unplug the cord supply
from the socket, turn over and slightly shake the toaster. Do never touch the parts of the toaster with cutting
utensils, especially inside the slots.
After each use open the removable crumb tray, empty it and clean with a soft dampened cloth.
9