LG WM22RV2S6 El Manual Del Propietario página 33

Using Washer Cycle
Inicio remoto (Remote Start)
Use a smart phone to control your appliance remotely.
You can also monitor your cycle operation so you know
how much time is left in the cycle.
To use Remote Start:
1
Press the Power button.
2
Put the laundry in the drum.
3
Press and hold Inicio remoto button for 3 seconds
to enable Remote Start function.
4
Start a cycle from the LG SmartThinQ application
on your smart phone.
NOTE
• Once the Remote Start mode is enabled, you can
start a cycle from the LG SmartThinQ smartphone
application. If the cycle is not started, the machine
will wait to start the cycle until it is turned off
remotely from the application or the Remote Start
mode is disabled.
• When Remote Start is turned on, the door is
automatically locked.
To disable Remote Start:
When the Remote Start is activated, press and hold
Inicio remoto button for 3 seconds.
Ciclo Descargado (Download Cycle)
Download new and special cycles that are not included
in the basic cycles on the appliance.
Appliances that have been successfully registered can
download a variety of specialty cycles specific to the
appliance.
Only one cycle can be stored on the appliance at a time.
Once cycle download is completed in the appliance, the
product keeps the downloaded cycle until a new cycle is
downloaded.
Open Source Software Notice Information
To obtain the source code under GPL, LGPL, MPL, and
other open source licenses, that is contained in this
product, please visit http://opensource.lge.com.
In addition to the source code, all referred license terms,
warranty disclaimers and copyright notices are available
for download.
LG Electronics will also provide open source code to you
on CD-ROM for a charge covering the cost of performing
such distribution (such as the cost of media, shipping,
and handling) upon email request to opensource@lge.
com. This offer is valid for three (3) years from the date
on which you purchased the product.
The operation is subject to the following two conditions:
(1) this device may not cause harmful interference and
(2) this device must accept any interference received,
including interference that may cause undesired
operation of the device.
33