Specifi Cations - PBU 56381410 Libro De Instrucciones

A-8 / ENGLISH
MAINTENANCE OF EQUIPMENT
WARNING!
The proper maintenance of equipment is vital to safe operation. LPG engines are dependent on engine tune up, and air fi lter replacement. CO
concentration (production) skyrockets when the air to fuel ratio becomes fuel rich. Follow the recommended Maintenance Schedule for the engine
found in the Engine Operator/Owner Manual as well as the Maintenance And Adjustments schedule found in the Propane Floor Equipment
Operator's Manual that were supplied with the equipment.
CO SAFETY EQUIPMENT AVAILABLE BY MANUFACTURER
• Carb Gard automated emissions monitoring will shut down the engine when high emissions are detected.
• Three-way type catalytic converter to scrub CO, Hydro Carbons (HC), and Nitrous Oxide (NOx) from the engine exhaust providing the lowest possible
emissions
• NOTE: Dead Stop CO Detector provided in Literature Pack. Replacement part number 98758A.
CO SAFETY EQUIPMENT AVAILABLE ON THE MARKET
• Positive or negative pressure high volume ventilation blower capable of exchanging complete room air volume to maintain CO levels below OSHA exposure
limits.
• Digital combustion analyzers for tail pipe emissions monitoring
• OSHA Approved CO Monitor
SPECIFICATIONS:
Model
Part Number
Brush Size
Engine
Catalytic Muffl er
Carb Gard
Clutch
Brush Speed
Propane Tank
Auto Fuel Shutoff
Low Oil Shutdown
Hour Meter
Sound Pressure (ISO 11201)
Agency Approvals
CARB Certifi ed
(California Air Resource Board)
Weight
Length
Width
Height
Warranty
A-8 - FORM NO. 56091024 - PBU Propane Stripper
21KBCATCLST
56381410
21" (53 CM)
603CC KAWASAKI
Yes
Yes
Centrifugal
1400 RPM
20 lb. (9.1 kg) Capacity, 80% Safety fi ll
Yes
Yes
Yes
87 dB LpA, 3dB KpA
EPA plus UL Approved Propane Components
Yes
242 lbs / 110 kg.
51.5" (131.8 cm)
23.3" (59 cm)
43" (109.2 cm)
2 Years Parts & Labor