Targa TAG-1900 Manual De Instrucciones página 5

OPERATING INSTRUCTIONS
1. POWER ON/OFF
Insert the front panel in the unit and push Power button in order to switch on the unit. Push
newly in order to switch off the unit and push REL button (15) to release the front panel.
Note: Never release the front panel when the unit is on. Power remains on even when car
radio is off.
2. SELECT
3. VOLUME UP/DOWN
Turing the VOL knob to right or left (3) to control the VOLUME. To select other functions, press
the SEL (2) button shortly until the desired functions is shown on the display. Figure 1 shows
how control functions are selected using the SEL button.
1
1. VOLUME
These buttons can be used to adjust the BASS, TREBLE, BALANCE and FADER.
AUDIO DSP CONTROLS (2)
When press the SEL button for more than 2 seconds, it is activated as selecting mode of these
function.
2 sec.
SEL DSP
DSP can be selected by turing the VOL knob to right or left (3)
POP M---ROCK M---CLASS---FLAT M---DSP OFF
ESP MODE (2)
When press the SEL button for more than 2 seconds, it is activated as 12 sec. or 45 sec. of
ESP mode can be selected.
2 sec.
SEL DSP
BEEP MODE (2)
When press the SEL button for more than 2 seconds, it is activated as selecting mode of these
function.
2 sec.
SEL DSP
BEEP ON: BEEP sound can hear from speaker when the buttons are pressed.
SEEK MODE (2)
When press the SEL button for more than 2 seconds, it is activated as selecting mode of these
function.
2 sec.
SEL DSP
SEEK 1: When SEEK 1 mode is activated, AUTO SEEK SCAN is stopped when station is
detected even user still push SEEK button.
SEEK 2: Auto SEEK SCAN is not stopped even station is detected if user push SEEK button.
When release this SEEK button, then stop when station is detected.
2 3 2
Fig. 1 Selection of sound control functions
2. SELECT 3. BASS
POP M --- ROCK M --- CLASS --- FLAT M --- DSP OFF
VOL
SEL ESP
VOL
SEL ESP SEL
SEL ESP SEL
4 2 5
4. TREBLE
ESP 12s. / 45s.
BEEP ON/OFF
VOL
BEEP SEL SEEK
E-4
2 6 2
5. BALANCE 6. FADER
SEEK1 / SEEK 2
VOL
button