Husqvarna HU725AWD/BBC Manual De Operario página 15

Ocultar thumbs Ver también para HU725AWD/BBC:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

CLEANING
IMPORTANT: FOR BEST PERFORMANCE, KEEP MOWER
HOUSING FREE OF BUILT-UP GRASS AND TRASH. CLEAN
THE UNDERSIDE OF YOUR MOWER AFTER EACH USE.
CAUTION: Disconnect spark plug wire
from spark plug and place wire where it
cannot come in contact with plug.
Clean the underside of your lawn mower by scraping
to remove build-up of grass and trash.
Clean engine often to keep trash from accumulating. A
clogged engine runs hotter and shortens engine life.
Keep fi nished surfaces / wheels free of gasoline, oil,
etc.
With the exception of the water washout port (if
equipped), we do not recommend using a garden
hose to clean the outside of your lawn mower unless
the elec tri cal system, muffl er, air fi lter and carburetor
are covered to keep water out. Water in engine can
result in shortened engine life.
CLEAN UNDER DRIVE COVER
Clean under drive cover at least twice a season. Scrape
underside of cover with putty knife or similar tool to remove
any build-up of trash or grass on underside of drive cover.
WATER WASHOUT FEATURE (See Fig. 19)
Your lawn mower is equipped with a fi tting that allows quick
and easy cleaning of the underside of the housing. To use
this feature, proceed as follows:
1. Move lawn mower to an area of cut grass or another
hard surface.
NOTE: Water, grass and other debris will drain from beneath
the mower housing during the washout process.
2. Remove grass catcher and discharge chute assembly
from lawn mower.
3. Close mulcher door (if equipped).
4. Connect a garden hose to the fi tting where shown.
IMPORTANT: BE SURE THE GARDEN HOSE IS NOT ROUTED
UNDER THE LAWN MOWER HOUSING OR ENTANGLED IN
THE WHEELS.
MAINTENANCE
5. Turn on water supply and check for leaks at the fi tting.
If no leaks are present, start engine (as described in the
Operation section of this manual) and let engine run until
the underside of the lawn mower is clean.
6. Shut off the engine.
7. Shut off water supply and remove hose from fi tting.
8. Start engine (as described in the Operation section
15
WARNING: Do not engage the drive
system during the washout process.
CAUTION: Do not remove hose from
fi tting while engine is running. Water
in engine can result in shortened en-
gine life.
of this manual) and let engine run for a full minute to
remove excess water from mower.
FIG. 19
HOSE
FITTING

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

961450018

Tabla de contenido