Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
This product will accept Craftsman C3 19.2V lithium-ion battery packs. For
complete charging instructions, refer to the Operator's Manual for the battery
packs and chargers.
ѥ
WARNING: To prevent accidental starting that could cause serious personal
injury, always remove the battery pack from the tool when assembling parts,
making adjustments, installing or removing bits, cleaning, or when it is not
in use.
TO ATTACH BATTERY
PACK (Fig. 2)
1.
Lock the trigger switch on
the drill/driver by placing the
direction-of-rotation (forward/
center-lock/reverse) selector
in the center position.
2.
Align the raised rib on the
battery pack with the groove
inside the drill/driver, and then
insert the battery pack into
the tool.
NOTICE: Make sure that the latch on the battery pack snaps into place and
the battery pack is secured to the tool before beginning operation. Improper
assembly of the battery pack can cause damage to internal components.
TO DETACH BATTERY PACK (Fig. 2)
1.
Lock the trigger switch on the drill/driver by placing the direction-of-rotation
selector in the center position.
2.
Depress both battery-release buttons, located on the sides of the battery
pack, to release the battery pack.
3.
Pull the battery pack out and remove it from the tool.
ѥ
WARNING: Battery tools are always in operating condition. Therefore, the
direction-of-rotation selector should always be locked when the tool is not in use
or when carrying the tool at your side.
OPERATION
Fig. 2
Rib
12
Latch
Battery-
Release
Button
Publicidad
Tabla de contenido
