VONROC PW504AC Manual Del Usuario página 9

5. Check gauze filter (3) is clear of any blockage
and assemble on the machine as shown in Fig.
C4.
6. Connect the water supply hose.
7. Check that the hose has no kinks in it.
8. Turn on water and check for leaks.
9. Squeeze trigger to allow air to be expelled
though the pump and hoses, lock trigger as
shown in Fig. C5.
10. Plug in machine and turn on switch (2).
11. Unlock trigger as shown in Fig. C5 and use the
pressure washer.
Patio cleaner (Fig. A)
The patio cleaner (16) is ideally suited for the
cleaning of floor and wall surfaces made of
different materials such as wood, plastic, concrete,
tiles, and natural stone.
1. Connect the patio cleaner lance to the patio
cleaner (16) as shown in figure A.
2. Connect the lance extension to the (15) patio
cleaner (16).
3. Connect the set to the spray gun (9).
Shut down
Never disconnect the high pressure hose
(14) from the machine while the system is
still pressurized.
ALWAYS turn off the unit's motor BEFORE
turning off the unit's water supply. Serious
damage could occur to the motor if the unit
is run without water.
1. Turn off the motor (push switch (2) to the off
position).
2. Unplug the unit from the power source.
3. Turn off the water supply.
4. Press the trigger of the gun (9) to depressurize
the system.
5. Disconnect the garden hose from the pressure
washer.
6. Engage the gun safety lock as shown in Fig. C5.
7. Wipe all surfaces of the unit with a damp clean
cloth.
Water supply
This unit is to be used with a cold-water
source only!
WWW.VONROC.COM
• Ensure that you have a suitable water supply
to feed the pressure washer. Check that all
connections are tight and there are no leaks in
the hose.
• The supply tap should be fully open (do not turn
on the pressure washer yet).
• Now depress the trigger (unlock trigger lock
first) to let water pass through the unit and
expel any air.
• Turn on the pressure washer, once all the air
has been expelled and water has reached the
end of the lance.
Adjusting the nozzle (Fig. D)
• Water may be sprayed out of the nozzle either
linearly or in a fan shape. Turn on the pressure
first, and then adjust the nozzle.
Using detergents (Fig, E)
The detergent bottle will allow you to apply many
forms of liquid detergent onto the work surface.
1. Remove the detergent dispenser of the
detergent reservoir and fill with liquid detergent
only. Do not put any water into the reservoir. The
pressure washer will mix water and detergent
automatically.
2. Insert the end of the detergent dispenser
into the gun, push and turn in the clockwise
direction to lock the detergent dispenser and
spray gun together.
When finished applying the detergent to the work
surface, it is possible to spray off the detergent by
using the spray lance.
5. MAINTENANCE
Before cleaning and maintenance, always
switch off the machine and remove the
mains plug from the mains.
Clean the machine casings regularly with a soft
cloth, preferably after each use. Make sure that
the ventilation openings are free of dust and
dirt. Remove very persistent dirt using a soft
cloth moistened with soapsuds. Do not use any
solvents such as gasoline, alcohol, ammonia, etc.
Chemicals such as these will damage the synthetic
components.
EN
9