Installing And Removing The Battery Pack - Craftsman CMCN618 Manual De Instructiones

Fig. B
22
11
Adjusting Depth (Fig. C)
The depth that the fastener is driven can be adjusted using
the depth adjustment wheel

WARNING: To reduce risk of serious injury from
accidental actuation when attempting to adjust
depth, ALWAYS:
• Remove battery pack.
• Engage trigger lock-off.
• Avoid contact with trigger during adjustments.
Depth settings are on a sliding scale. The left side indicating
the deepest and the right side indicating the shallowest.
1. To drive a nail deeper, rotate the depth adjustment
wheel 3 downwards. This will slide the depth
adjustment indicator 4 to the left on the scale.
2. To drive a nail shallower, rotate the depth adjustment
wheel upwards. This will slide the depth adjustment
indicator to the right on the scale.
Fig. C
3
Preparing the Tool

WARNING: NEVER spray or in any other way apply
lubricants or cleaning solvents inside the tool. This can
seriously affect the life and performance of the tool.
nOTE: The battery pack is not fully charged out
of the carton. Follow instructions outlined (see
Charging a Battery).
on the side of the tool.
3
4
1. Read the Safety Warnings sections of this manual.
2. Wear eye and ear protection.
3. Ensure magazine is empty of all fasteners.
4. Check for smooth and proper operation of contact
trip and pusher assemblies. Do not use tool if either
assembly is not functioning properly. nEVER use
a tool that has the contact trip restrained in the
actuated position.
5. Keep tool pointed away from yourself and others.
6. Insert fully charged battery pack.
OPERATION

WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.

Installing and Removing the Battery Pack

(Fig. D)
nOTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack 12
battery pack with the rails inside the tool's handle and slide
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release
button and firmly pull the battery pack out of the tool
13
handle. Insert it into the charger as described in the charger
section of this manual.
Fig. D
12
Proper Hand Position (Fig. E)

WARNING: To reduce the risk of serious personal
injury, ALWAYS use proper hand position as shown.

WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Proper hand position requires one hand on the main
handle 15 .
English
into the tool handle, align the
13
9