Craftsman CMCN618 Manual De Instructiones página 17

Tool operates, but no fastener driven No fasteners in magazine
Jammed fastener
Wrong size or angle fasteners
Debris in nosepiece
Debris in magazine
Worn magazine
Damaged or worn driver blade
Damaged pusher spring
Wrong size or angle fasteners
Damaged or worn driver blade
Material and fastener length too rigorous
an application
Low battery charge or damaged battery
Debris in nosepiece
Debris in magazine
Worn magazine
Worn or damaged pusher spring
Load fasteners into magazine
Use only recommended fasteners
Clean nosepiece
Clean magazine
Replace magazine; see authorized
service center
Replace driver/return assembly; see
authorized service center
Replace spring; see authorized
service center
Use only recommended fasteners
Replace driver/return assembly; see
authorized service center
Material or fastener
length inappropriate
Charge or replace battery
Clean nosepiece
Clean magazine
Replace magazine; see authorized
service center
Replace spring; see authorized
service center
English
15