The Starpointer Finderscope - Celestron AstroMaster AZ Serie Manual De Instrucciones

THE STARPOINTER FINDERSCOPE

Your telescope comes with a StarPointer red-dot
finderscope that you will use as a sighting tool when
aiming the telescope at a target
To install the finderscope on the 70AZ, 90AZ,
and 102AZ:
1 . Loosen the two Philips–head screws on the side of
the finderscope and slide the clamp over the dovetail
bracket near the telescope focuser The large window
on the finder should be facing the front of the telescope
2 . Secure the finderscope in place by tightening the two
Philips-head screws Do not over tighten these screws
Just make the connection snug
3 . emove the small plastic tab under the battery cover
R
by pulling it straight out This is installed to prevent
the battery from accidentally discharging during
transportation
To install the finderscope on the 80AZS:
1 . Loosen the finger screw on the dovetail mount on the
top left of the focuser
2 . Slide the dovetail slider on the bottom of the finder
bracket into the dovetail mount on the focuser
3 . Tighten the finger screw to secure it in place
Left/Right
Adjustment
Knob
On/Off Switch
Up/Down
Adjustment
Knob
Battery
Compartment
ENGLISH I 9