Resetting The Ax-Gmlan11-Swc - Axxess AX-GMLAN11-SWC Instrucciones De Instalación

Resetting the AX-GMLAN11-SWC

1. With the radio on, turn the potentiometer:
Note: Before proceeding, remember the position the potentiometer is at.
Turn left the LED will come on
Turn right the LED will come on
Turn back left the LED will come on
Turn right the LED will come on
Turn back left the LED will begin to flash rapidly
Turn back to the initial position
The rapid flash means the interface is starting its re-programming process.
2. The L.E.D. inside the interface will turn off for a couple seconds, then flash fast, then flash slowly
(up to (18) times, indicating which radio is connected to the interface), and then turn off. Pay
close attention as to how many slow flashes there are. This will help in troubleshooting, if need
be. Refer to the L.E.D. feedback section for more information.
3. Within a few seconds the L.E.D. will turn on, and the radio will turn off.
4. Within a minute the L.E.D. will turn off, and the radio will come back on, indicating the
resetting and initialization process was successful.
10
STEERING WHEEL CONTROL SETTINGS
hold until the LED goes out
hold until the LED goes out
hold until the LED goes out
hold until the LED goes out
(CONT)