Resetting Or Forcing Auto Learn On The Swc - Axxess CLASSII-100 Instrucciones De Instalación

Remapping the SWC buttons
Note: Not all radios will have all of these commands. Please refer to the radio's owners
manual for specific commands recognized by that radio.
For instance, the next command to be mapped is the "Volume Down" command. Let's
say you want the "Mode" button on your steering wheel to be the "Volume Down"
command. Hold down the "Mode" button till the LED lights up solid red and then
release it. Now the "Mode" button on the steering wheel is "Volume Down".
6.
After the last button is programmed on your steering wheel (you do not have to go
through the whole list), hold down the "Volume Up" button for at least 10 seconds then
the LED will go out.
After the 18th button is programmed and/or skipped the LED will go out and remapping
is completed.
If after remapping the SWC and you want to revert the SWC back to its original settings
follow these steps below:

Resetting or Forcing Auto Learn on the SWC

1) Within the first 20 seconds of turning the ignition on. Press and hold down the
original "Volume Up" button for at least 25 seconds.
2) The LED will blink rapidly.
3) Release the "Volume Up" button and wait until the LED goes on solid.
4) After the LED goes off the original steering wheel control settings will be restored.
CLASSII-100
----- OR -----
10