Attach Suction Hose; Connect Discharge Hose (Optional) - Briggs & Stratton Pro Serie Manual De Instrucciones

Ocultar thumbs Ver también para Pro Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

High Altitude
At altitudes over 5,000 feet (1524 meters), a minimum
85 octane / 85 AKI (89 RON) gasoline is acceptable. To
remain emissions compliant, high altitude adjustment is
required. Operation without this adjustment will cause
decreased performance, increased fuel consumption, and
increased emissions. See an Authorized Briggs & Stratton
dealer for high altitude adjustment information. Operation of
the engine at altitudes below 2,500 feet (762 meters) with
the high altitude kit is not recommended.

Attach Suction Hose

You will need the following tool to install the hoses to the
trash pump:
• 1/4" or 6mm standard screwdriver
Connect Suction Hose to Pump
Use a commercially available hose. The suction hose must
be reinforced with a non-collapsible wall or braided material.
DO NOT use a hose with an inside diameter smaller than the
pumps suction port size.
1. Slide barb cuff (A) over hose barb (B). Insert rubber
seal (C) into end of barb cuff.
B
2. Screw hose barb assembly onto pump in clockwise
rotation until hose barb assembly is tightened securely.
3. Slide hose clamp (D) over end of hose (E). Slide
suction hose onto hose barb (F). Tighten hose clamp
securely using a standard 1/4" (6mm) screwdriver.
F
D
E
8
A
C
Attach Suction Hose to Strainer Basket
Slide hose clamp over hose. Attach open end of suction hose
to strainer hose barb. Tighten hose clamp securely using a
standard 1/4" (6mm) screwdriver.

Connect Discharge Hose (Optional)

If desired, use a commercially available hose. DO NOT use a
hose with an inside diameter smaller than the pump's
discharge port size.
1. Slide barb cuff over hose barb. Insert rubber seal into
end of barb cuff as shown earlier.
2. Screw hose barb assembly onto pump in clockwise
rotation until hose barb assembly is tightened securely.
3. Slide hose clamp over end of discharge hose. Slide
discharge hose onto hose barb. Tighten hose clamp
securely using a standard 1/4" (6mm) screwdriver.
BRIGGSandSTRATTON.COM

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

205378gs

Tabla de contenido