Costan LION CUB Serie Instrucciones De Uso página 27

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 39
te preservation temperature.
·
Wait until the cold room has reached ambient temperature.
·
Clean the display case inside thoroughly with mild soap or detergent and lukewarm water. Wipe carefully with and
a soft cloth.
·
After having carefully checked that the display case is completely dry inside, start the appliance again by the wall
cut-out switch. Allow a couple of hours before loading the products back again.
·
Allow a couple of hours before loading the products back again.
4) Every six months clean the honeycomb , in the following way (fig. 16 - pag. 7)
a) Loosen the screws fixing the support;
b) remove the honeycomb;
c) use a jet of hot water (max. 70°C) to remove any dust which may have accumulated on the honeycomb;
d) dry with a jet of air;
e) replace the honeycomb with great care.
Disassemble and assemble very slowly, using work gloves. It is advisable to have these cleaning ope-
rations carried out by authorized service personnel.
Any maintenance operation not included among the former steps must be carried out by the authorised after-
sales service or by qualified personnel.
CANOPY AND SHELF LIGHTING: canopy and shelf lamps must be replaced by the after-sales service only. Resort
to it if need be.
If you should wish to eliminate shelf lighting, let it be done by the authorised after-sales service.
11. EMERGENCY SITUATIONS
1) The display case will not start or will not keep on working:
• There may be a general black-out;
• The wall main switch may be off.
If power failure is not due to any of the above causes, call the nearest after-sales service immediately,
empty the display case and store the foods in coldrooms or refrigerators that may ensure preservation
temperature.
2) The display case will not cool properly
• Make sure that the product load is correct and the air slots are not covered;
• defrost and clean it before starting normal operation (see chapter 10);
• Make sure that the case is not exposed to sources of heat or draught;
• Check that the display case is perfectly horizontal by the use of a spirit level. Make certain that ambient conditions
comply with the requirements of page 4.
Should insufficient cooling persist, resort to the nearest after-sales service.
3) The cabinet operates noisily:
• Make sure that screws and bolts are closed tight.
• Check that the display case is perfectly horizontal by the use of a spirit level.
IN CASE OF A GAS LEAK OR FIRE, do not breathe inside the room that houses the display case before
having aired it properly. Turn the display case off by the main switch ahead (see fig. 17). DO NOT USE
WATER BUT ONLY DRY EXTINGUISHERS TO EXTINGUISH THE FIRE.
18

Publicidad

Tabla de contenido
loading

Tabla de contenido