Saber K00SB5317 Guía De Montaje página 6

Cleaning the Burner Assembly
Follow these instructions to clean and/or replace parts of burner
assembly or if you have trouble igniting side burner.
1. Turn gas OFF at control knobs and gas source.
2. Remove cooking grate.
3. Remove screws securing ignitor and burners.
4. Remove ignitor electrode but leave connected to ignition wire.
5. Carefully remove inner burner.
6. Carefully remove outer burner.
Remove screws
Remove inner burner
Remove outer burner
7. We suggest three ways to clean the burner tubes. Use the one
easiest for you.
(A) Bend a stiff wire (a light weight coat hanger works well) into
a small hook. Run the hook through each burner tube
several times.
(B) Use a narrow bottle brush with a flexible handle (do not use
a brass brush), run the brush through each burner tube
several times.
(C) Wear eye protection: Use an air hose to force air into the
burner tube and out the burner ports. Check each port to
make sure air comes out each hole.
8. Wire brush entire outer surface of burner to remove food
residue and dirt.
9. Clean any blocked ports with a stiff wire such as an open paper
clip.
10. Check burner for damage, due to normal wear and corrosion
some holes may become enlarged. If any large cracks or holes
are found replace burner.
11.Carefully replace burners and secure with screws removed in
step 3. VERY IMPORTANT: Burner tubes must re-engage
orifice holder.
12. Replace ignition electrode and secure with screw.
13. Check ignition operation.
14. Replace cooking grate.
Installation Requirements
Ensuring proper Combustion Air and Cooling Airflow
Proper airflow MUST be maintained for the side burner to
Ÿ
perform as it was designed. If airflow is blocked, overheating
and poor combustion will result.
6
Correct
burner-to-orifice holder
engagement