Hayward AquaRite + Manual Del Usuario página 43

Setting the pump type
1
OK
6
1
OK
5
+
-
Lighting
1
OK
1 Lighting.
2
Manual mode (ON/OFF).
3
Automatic mode: Starts up according to the
time slots used to set the lighting start and end
times. The time slots can be configured with
the following frequencies: daily, every 2 days,
Page 19 of 23
2
3
Enter the Service menu from the
configuration menu.
4
Enter the password (contact Hayward's
technical support for the code)
5
Enter the Pump type menu.
2
+
-
6
+
-
2
OK
every 3 days, every 4 days, every 5 days,
weekly, every 2 weeks, every 3 weeks, every 4
weeks.
4
LED light: If you are using a coloured LED
light, go to the menu to configure it.
USE ONLY GENUINE REPLACEMENT PARTS
3
OK
6
Select the type of pump.
The default pump type is "standard"
(single-speed).
If you are using a variable-speed pump,
select "Variable speed".
In this case, one of the 3 speeds (V1,
V2, V3) can be assigned to the heating
and when the cover is closed.
3
7
+
-
3
OK
AquaRite +
4 5
OK
4
After connecting a variable speed pump, you can
assign a different speed individually to each filtration
period, as required.
V1: S, V2: M, V3: F
Filter cleaning: To clean the filter with a variable-
speed pump, it is best to use the highest speed
(V3).
4
OK
5 Colour selection: This menu allows you to
change the colours manually and, according to
the type of LED light, program the pulse length
required to cycle through the colours and
programs (by default, 0.5 s, maximum 10 s).
6
5
Rev. E