How To Operate - Nostalgia Products IGLOO ICEC33SB Instrucciones Y Recetas

HOW TO OPERATE

BEFORE FIRST USE
1. Follow the steps under CLEANING & MAINTENANCE before using this unit.
2. Place the unit on a flat, level surface in a location that is protected from
direct sunlight and other sources of heat (i.e. stove, furnace, radiator). Ensure
there is at least four inches of empty space on all sides of the unit.
3. Allow one hour for the refrigerant fluid to settle before plugging
the cord into an electrical outlet for the first time.
USING YOUR ICE CUBE MAKER
1. Open the Clear Lid to remove the Ice Basket and pour water into the Water
Reservoir. Keep the water level below the drainage hole to avoid spilling water.
2. Press the button on the LED Control Panel to begin the ice-making cycle.
3. Select the desired size of the ice cubes by pressing the
room temperature is lower than 60°F (16°C), it is recommended to select
the small-sized ice cubes in order to keep ice from sticking together.
4. Each ice-making cycle depends on the size of the ice cube selected
and the ambient temperature of the room. In extremely hot
temperatures, ice-making time may vary considerably.
5. While the ice maker is on, check the water level periodically. If the water pump is unable
to pump water, the unit will stop automatically and the
6. If the water level is low, press the
Reservoir with water and press the
7. The unit automatically stops working when the Ice Basket is full and the
illuminate.
NOTE: Unit will automatically shut-off after 16 hours of non-use.
8. To ensure a reasonable hygiene level, change the water in the Water Reservoir
every 24 hours. If the unit isn't in use, drain all water left in the Water Reservoir.
IMPORTANT NOTE: In the event that the power is disconnected during the ice making
cycle or that the LED lights on the Control Panel are blinking, press the
stop the ice making cycle. Unplug the unit from the electrical outlet. Allow the unit
to sit for a few minutes to let it warm up and allow ice to fall from the evaporator
fingers. Empty the Water Tray and wait three minutes before restarting the unit.
DO NOT touch the Evaporator while the unit is in use or during the ice making
process. This could cause severe burns.
button. If the
button to turn the unit OFF, fill the Water
button again to turn ON the unit again.
light will illuminate.
light will
button to
6