How To Operate - Nostalgia Products RETRO RSM650 Serie Instrucciones Y Recetas

HOW TO OPERATE

1. First, find a stable, waterproof surface near an electrical outlet before
starting. Make sure the cord is away from any water source.
2. DO NOT place the RETRO SERIES™ SLUSH MACHINE near the edge of a table or countertop.
3. Remove the Blending Chamber Lid by pinching the lock tab together
while lifting up on the Lid and carefully unhinging the front.
4. Add ½ cup of regular table salt, rock salt, or kosher salt and ½ cup of water in the Aluminum
Cylinder (be sure to add salt first then water in order to mix well).
Salt is necessary for the freezing process. It may take ½ cup of salt
or more for your slush to freeze properly. Return the Lid to Blending
Chamber, making sure it is aligned properly over the mixing
mechanism and locked down securely to the clear mixing chamber.
5. Slide the ON/OFF switch back to FREEZE to turn the unit on
and begin the slush making process. DO NOT turn the unit
OFF during use as the Aluminum Cylinder may freeze.
6. Fill the Aluminum Cylinder with small or broken pieces of ice
through opening labeled ICE AND SALT, to within 1 inch of the
Aluminum Cylinder top. Ensure that the Spout is in the closed position to avoid spillage.
7. Pour your selected beverage directly into the unit through the molded square indention
located on the top of your RETRO SERIES™ SLUSH MACHINE. DO NOT fill beyond the
MAX FILL line (approximately 1 qt. of liquid). Sugar-free beverages and alcoholic
beverages will not freeze. DO NOT use them in the machine.
NOTE: Do not use the slush maker to freeze liquids
without any sugar (such as water), as this may damage the
appliance. Water will freeze very quickly to the exterior
of the ice cylinder and could damage the unit.
8. Allow the mixture to blend for up to 25 minutes until
you reach the desired slush consistency. If Lid should
pop off while machine is mixing, turn ON/OFF switch
to OFF, use spoon or spatula to scrape any ice that may
build up on outside of Aluminum Cylinder, and replace
Lid. Turn ON/OFF switch back to FREEZE and continue mixing
NOTE: You can continually add ice and salt to the unit as you are creating slush by
dropping ice and salt into the round, open hole in the Lid above the Aluminum
Cylinder. DO NOT exceed filling the Aluminum Cylinder 1 inch from the top as
there is a risk that the slush mixture will become contaminated with salt.
9. When mixture reaches desired consistency, place cup under
Spout and slide the ON/OFF switch forward to DISPENSE.
Turn the slush dispenser handle to the right to dispense
drink. Keep unit running until all slush has been dispensed.
Be sure to turn handle back to CLOSE after filling each cup.
NOTE: If slush gets too thick, or does not dispense well,
add more liquid to the mixing chamber opening.
6