OPERATING INSTRUCTIONS
Properties and parameters
•
High precision tensometric sensor.
•
Multifunction mode: index measurement of fat, water, muscle and bone and calculation of the
recommended intake of calories.
•
Built-in memory for 12 diff erent users.
•
Selectable basic weighing mode (skipping parameters settings): Automatic weighing when stepping on
the scale and adding weight when reweighing.
•
Low battery and overload indicator.
Buttons functions
SET
GB
Battery inserting / replacement
1.
First, remove from the new batteries contact the insulating foil.
2.
Open the battery compartment cover on the bottom of the scale.
3.
Remove the empty battery.
4.
Insert new battery and close the battery space cover. Make sure the polarity is correct.
Setting the weight unit
On the bottom of the scale is the button for unit change, see picture.
Press this conversion button to change the weight units. When the
scale is off , press the conversion button, the LCD display shows the
current unit of weight. Press again to switch to the required unit.
After selecting the preferred unit, the scale shuts down
automatically after 20 seconds. The next time you turn on the scale,
weight will be displayed in the newly selected units.
•
When setting units of weight to lb, the of height will default to
feet / inches.
•
When setting units of weight to kg, the height units will default to centimetres.
Note: The default measurement system of the scale depends on the region.
Automatic weight measurement
Automatic weighing when stepping on the scale
Install the battery (see
above) and place the scale
on an even fl oor
54
Switching on the scale and advance to the next parameter (please see setting personal
parameters)
Each pressing increases the parameter value after each step. Holding down the button will
speed up the increase of value.
Each pressing decreases the parameter value after each step. Holding down the button will
speed up the decrease of value.
Step on the scale
(Without parameters setting)
Your weight will be
displayed
Press
The numbers fl ash,
stabilize and lock
Press