Aircare MA0800 Manual De Instrucciones página 4

ABOUT THE CODES
F – The F code means your unit is empty and needs to be FILLED with water.
CL – Your CONTROLS ARE LOCKED on the current setting. Activate the control lock by holding the power button for five seconds, until CL
appears. Your Mini-Console will lock on the current fan and humidity settings. Release the lock by pressing the power button again for five
seconds until the display flashes CL twice, letting you know the lock is off.
CF – The CF code triggers after 720 hours of use and means it's time to CHECK YOUR FILTER (wick). Unplug your unit and check your
wick. If your wick is still in good shape, simply clear the code by plugging your humidifier back in. If your wick needs replacing, follow these
quick steps:
1. Remove the water bottle and top from the base.
2. Replace your old wick with a new MAF2 Super Wick®. Wrap the wick through the base guides in a circle so the wick's ends meet.
3. Put the top and water bottle back on the base.
8
Plug in your unit and press the power
button power-of.
9
Set your desired fan speed by pressing
the fan button . Your Mini-Console
has three fan speeds that are displayed by
F1 (the lowest speed) through F3 (the highest
speed). The additional AUTO setting (displayed
by an A) allows the fan speed to adjust
automatically to your humidity setting.
Note: On higher speeds, the Mini-Console puts out a tremendous
amount of humidity, so it's louder on these levels. Most of our
customers liken it to the sound of a box fan. Rest assured there is
nothing wrong with your unit, it's just working very hard to put out
much-needed humidity.
10
Press the humidity control button
set your humidity level from 25% to 65%.
The humidistat on your cord will read your home's
humidity and turn your fan off when the set level
is reached. When set to 65%, your unit will run
continuously.
That's it! Your Mini-Console is ready to use.
HOW TO CLEAN YOUR MINI-CONSOLE
Regular cleaning is important for preventing mold,
mildew, and other bacterial growth in your humidifier.
It also keeps your Mini-Console working its best.
1. Let the unit run until it's empty, then turn it off and
unplug it.
2. Remove the water bottle and the top from the base.
3. Throw your wick away if it is time to replace it.
Otherwise, remove it from the base and put the wick in
a sink while you finish cleaning your Mini-Console.
4. Pour out any remaining water from the base and bottle.
5. Clean the base and bottle by filling each half-full with
to
water. Add 1 cup of white vinegar to each. Let these sit
for 20 minutes. To disinfect, replace the vinegar with 1
teaspoon of bleach in each. Do not mix vinegar and
bleach.
6. After 20 minutes, empty the base and bottle.
7. Dampen a sponge with white vinegar and wipe down
the base. Rinse it thoroughly. To disinfect, replace the
vinegar with bleach.
8. Wipe everything dry. Replace your wick or install a new
one, then reassemble the unit.
When storing your Mini-Console, discard the used wick
and disinfect the unit using the directions above. Dry the unit
thoroughly, and store in a temperature-regulated area. Do not
install a new wick until you are ready to use your humidifier
again.
6