Nevir NVR-4496 CTNF Manual De Instrucciones página 42

 The appliance is overfilled.
 The door seals are damaged.
Strong formation of encrusted ice.
 The door is not properly closed.
 The door seal is damaged or
soiled.
The door makes a strange sound when opened.
 The door seals are soiled.
 The appliance is not installed on a
level, dry and solid floor.
 The appliance is in contact with a
wall or another item. The bottles
are incorrectly positioned.
 Some items have dropped behind
the appliance.
 If the appliance shows a malfunction not noted on the schedule above or
if you have checked all items on the above schedule but the problem still
exists, please contactthe aftersales service.
The operating procedures described below are normal
 The refrigerant generates a sound similar to flowing water.
 Sometimes you may hear a sound which is generated by the injection
process of the cooling circuit.
 The sides of the appliance may get warm while the appliance is running.
When you run the appliance for the first time or the temperature falls below a
certain level the appliance will operate with high power to reach the preset
temperature.
Condensed water in/on the appliance
may be generated inside or outside the appliance by high humidity or very
warm ambient temperatures.
You will hear the compressor click when it is activated or deactivated.
is caused by the compressor while running.
may be generated by sequential expansion and shrinkage of the components
of the cooling system. It is caused by variation of temperature before and after
the compressor is activated or deactivated.
 Close the door.
 Clean/replace the door seal.
 Clean the seals.
Unusual noise.
 Realign the appliance.
 Readjust the appliance.
 Realign the bottles
 Remove these items.
and do not indicate a malfunction.
Distinct noise
Clicking
umH
Knocking/snapping