Before Initial Operation; Temperature Setting - Nevir NVR-4496 CTNF Manual De Instrucciones

WARNING
COMPRESSOR ONLY. You must unplug the appliance to
disconnect it from the mains.

4.2 Before initial operation

1. Clean the appliance thoroughly. Be very careful especially inside the
appliance (look at chapter
2. If the accessories inside the appliance are not fitted in their correct
position, replace them according to the image in chapter 4.
3. Use the freezer compartment 24 hours after initial operation of the
appliance.
4. The appliance must be connected to the mains properly.
5. If the appliance was disconnected from the energy supply, wait 5 minutes
before you restart it.
6. Do not overfill the appliance

4.3 Temperature setting

1. When you have connected the appliance to the mains for the first time, the
backlighting of the LED begins to flash. If no keys are operated and the doors are
closed, the backlighting goes off.
2. During initial operation, please set the temperature of the cooling compartment to +4
0
C und and the temperature of the freezerto -18
3. The set temperatures are average temperatures. The temperatures may vary depending
on the amount and storage areas of the food. The ambient temperature can also affect
the actual cooling temperatures.
Display control
Use your appliance according to the following control regulations, your appliance has the
corresponding functions and modes as the control panels showed in the pictures below. When
the appliance is powered on for the first time. The backlighting of the icons on display panel
starts working. If no buttons have been pressed and the doors are closed, the backlighting will
turn off
THE THERMOSTAT
CLEANING AND MAINTENANCE
CONTROLS
).
0
C.
THE