Inserting The Tool - BDS Maschinen MAB 455 Instrucciones De Manejo

St e e l o f l o w t h i c k n e s s
NF m e t a l s o r w o r k p i e c e s w i t h a n u n e v e n s u r f a c e
In s e r t i n g t h e t o o l
M A B 4 5 5
When drilling in steel of low thickness, an additional steel plate
(minimum dimensions 4" x 7-7/8" x 3/4" [100 x 200 x 20 mm])
must be placed under the workpiece . Secure the steel plate to
prevent it from falling .
A special holding device must be used when drilling in NF metals
or in workpieces with an uneven surface .
NOTE
► CS Unitec offers special clamping devices for tubes and
non-magnetic materials in its range of accessories .
The machine is equipped with an MK tool mounting . Depending
on the type of tool to be used, corresponding drill chucks, quick-
clamping systems or adapters must be employed .
T o o l
Tool with
taper MK
Tools with
19 mm Weldon shank
Tools with
straight shank
Thread taps
T o o l m o u n t i n g t o b e u s e d
Insert the tool directly into the morse
taper (3) .
Use KEYLESS quick-change drill chuck
system (A) .
Use drill chuck with MK2/B16 tapered
mandrel (available as an accessory) .
Use KEYLESS quick-change drill
chuck system (A) with the appropriate
adapter for thread taps (available as an
accessory .
P r e p a r a t i o n s
1 7