DeWalt DW800 Manual De Usuario página 21

• Ensure all materials to be ground or cut
are secured in place.
• Apply only a gentle pressure to the tool.
Do not exert side pressure on the
grinding wheel or cutting disk.
• Avoid overloading. Should the tool
become hot, let it run a few minutes
under no load condition.
Prior to operation:
• Install the appropriate guard and disk or wheel.
Do not use excessively worn disks or wheels.
• Be sure the spacer and threaded flange are
mounted correctly.
• Make sure the disk or wheel rotates in the
direction of the arrows on the accessory and
the tool.
Switching ON and OFF (fig. A & G)
• To run the tool, press the ON/OFF-switch (1) to
the front.
• For continuous operation, press down the front
end of the switch.
• To stop the tool, release the ON/OFF-switch.
To stop the tool in continuous operation,
press the rear end of the ON/OFF-switch.
Do not switch the tool on or off when
under load.
Sanding with the backing pad (option)
• Mount the backing pad with abrasive disk as
described above.
• Only a segment of the disk should
contact the workpiece when sanding.
• Do not exert excessive pressure on the
abrasive disk.
Consult your dealer for further information on the
appropriate accessories.
Maintenance
Your D WALT Power Tool has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
16
Lubrication
Your Power Tool requires no additional lubrication.
Cleaning
Keep the ventilation slots clear and regularly clean
the housing with a soft cloth.
Unwanted tools and the environment
Take your tool to an authorized D
agent where it will be disposed of in an
environmentally safe way.
E N G L I S H
WALT repair
E
en - 5