Dremel MM40 Instrucciones De Funcionamiento Y Seguridad página 11

DM 2610016364 02-12_DM 2610016364 02-12.qxp 2/27/12 7:35 AM Page 11
Please refer to figures 7 and 8 for further instruction on how to use your Dremel Multi-Max™.
Following these instructions will allow you to get the highest performance out of your oscilating tool.
CORRECT: Sand with a smooth
back and forth motion, allowing the
weight of the tool to do the work.
INCORRECT: Avoid sanding with
only the tip of the pad. Keep as
much sand paper in touch with the
work surface as possible.
CORRECT: Always sand with the
pad and sandpaper flat against the
work surface. Work smoothly in a
back and forth motion.
INCORRECT: Avoid tipping the
pad. Always sand flat.
FIG. 7
CORRECT: Always cut with a
smooth back and forth motion.
Never force the blade. Apply light
pressure to guide the tool.
INCORRECT: Do not twist the tool
while cutting.This can cause the
blade to bind.
CORRECT: Make sure flexible
scraper blade flexes enough
INCORRECT: Avoid screw head
touching surface with flexible
scraper blade.
-11-
BDL-2610016364, Page: MUL (VAA), downloaded at: 2017.03.17_15:51:06, by PT-RT/MKB2_Nicole.Hayden
FIG. 8