These pumps cannot be used in swimming pools, ponds or basins where people are present, or for
pumping hydrocarbons (petrol, diesel fuel, combustible oils, solvents, etc.) in accordance with the acci-
dent-prevention regulations in force. They should be cleaned before putting them away. See the chapter
"Maintenance and Cleaning".
2. PUMPABLE LIQUIDS
Clean, free from solid bodies or abrasive substances, non-aggressive.
Fresh water
Rainwater
(filtered)
Clear waste water
Dirty water
Fountain water (filtered)
River or lake water (filtered)
Drinking water
Suitable
Not suitable
o
3. TECHNICAL DATA AND LIMITATIONS OF USE
Supply voltage:115-120V, see electrical data plate
Delayed line fuses (115-120V version): indicative values (Ampere)
Storage temperature: 14F – 104F
Electrical data
P1 Rated absorbed power [W]
P2 [W]
USA P2 [HP] Fractional (decimal)
Mains voltage [V]
Mains frequency [Hz]
Current [A]
Capacitor [µF]
Capacitor [Vc]
Hydraulic data
Max. flow rate [gpm]
Max. head [ft]
Max. head [psi]
Max. pressure [psi]
Max suction depth [ft/min]
Switch-on pressure [psi]
Switch-off pressure [psi]
Pressure indicator
Range of use
Type of cable
Grade of motor protection
Insulation class
Liquid temperature range [F]
according to EN 60335-2-41 for domestic use
Max. particle dimension [in]
Max. ambient temperature [F]
Weight
DNM NPT
The pump cannot support the weight of the pipes, which must be supported in some other way.
4. MANAGEMENT
4.1
Storage
All the pumps must be stored in a dry covered place, with possible constant air humidity, free from vibrations and dust.
They are supplied in their original pack in which they must remain until the time of installation.
4.2
Transport
Avoid subjecting the products to needless impacts and collisions.
ENGLISH
Model
Table 2
2
o
o
Table1
P1=1050 W
1050
750
3/4 (0.75)
~ 115-120V AC
60
9.8
40
250
15,0
141.2
62.4
87
26.2/<3min
26.1
46.4
LED
SJTOW 16AWG
IP X4 / NEMA 1
F
+32 F / +95 F
Clean water
104
1'' M