Urrea 6006 Manual De Instrucciones página 4

• Do not use cheater extensions on the handle to
apply torque. Broken or slipping tools can cause
injury.
RATCHET
Ratchet mechanism may slip or break if dirty,
missmatched worn parts are used, or direction level
is not fully engaged.
MANTEINANCE / SERVICE
1. The torque wrench´s internal mechanism is
permanently lubricated during assembly. Do not
attempt to lubricate the internal mechanism.
2. Clean torque wrench by wiping. Do not immerse.
3. Store torque wrench in protective case at its
lowest torque setting. Do not force handle below
lowest setting.
USE INSTRUCTIONS & SETTING THE TORQUE
A. To unlock handle hold tube and pull lock ring
back allowing handle to turn CW or CCW.
B. Set wrench to desired torque as follows:
EXAMPLE-64 ft.lbs.
1. Keep slight rearward pull on lock-ring during all
adjustments.
2. Line up thimble edge with a "60" graduation
cross line and zero with vertical line. Wrench is now
set at 60 ft. lbs. (see fig.1).
3. Turn handle and set thimble graduation to "4"
on vertical line. Wrench is now set at 64 ft.lbs.
4. Lock handle by releasing back pressure on
lock-ring until it clicks and handle doesn´t turn.
5. To torque fastener, keep hand centered on the
grip handle. Apply a slow steady force in the
desired direction until a click-impulse is heard or
felt. Stop pulling and allow the wrench to reset.