Control Panel - Danby DVAC080B1WDB Manual Del Propietário

OPERATING INSTRUCTIONS

CONTROL PANEL

1. Exhaust Control:
• In the Closed position, the air conditioner will circulate inside air only. Use the Closed position when
maximum cooling is desired or for air circulation when the appliance is set to fan mode.
• In the Open position, the air conditioner will exhaust air to the outside. Use the Open position to
remove stale air from the room and exhaust it to the outside and to draw fresh air into the home.
2. Mode Button: Used to choose the operating mode.
3. Energy Saver Button:
• The Energy Saver Function will automatically cycle the fan on and off when the compressor is not in
use to minimize how often the compressor needs to turn on. This function is available in Cool, Dry,
Auto Cool and Auto Fan modes.
• The fan will continue to run for 3 minutes after the compressor turns off. The fan will then cycle on
for 2 minutes in 10 minute intervals until the ambient temperature is above the set temperature, at
which point the compressor will turn on and cooling will resume.
4. Timer Button: Used to set the auto on and auto off timer.
5. Up and Down Arrows:
• Used to adjust the set temperature and the timer function.
• Press and hold the up and down buttons at the same time for 3 seconds to change the temperature
display between °F and °C.
6. Display Panel: Displays the set temperature, the ambient temperature and the timer settings. To change
the temperature scale being displayed, press the up and down buttons at the same time.
7. Sleep Button:
• The Sleep Function can be used to conserve energy during sleeping hours. When selected, the set
temperature will increase by 1°C/2°F every half hour for one full hour. The appliance will hold the
new set temperature for 6 hours before automatically returning to normal operation.
8. Filter Button: The indicator light will illuminate as a reminder to check the fi lter. Once the fi lter has been
cleaned, use this button to resume operation.
9. Fan Button: Used to set the fan speed. The fan can be set to Low, Medium, High and Auto.
10. Power Button: Press to turn the appliance on or off.
11. Remote Control Receiver
3
1
2
4
5
9
7
8
6
10 11
9