Beta 1927AN Manual De Uso E Instrucciones página 9

PERSONAL PROTECTIVE EQUIPMENT TO WEAR WHILE OPERATING PNEUMATIC TOOL
Failure to observe the following warnings may result in physical injury and/or disease.
ALWAYS WEAR HEARING PROTECTION WHILE OPERATING PNEUMATIC TOOL
ALWAYS WEAR EYE PROTECTION WHILE OPERATING PNEUMATIC TOOL OR PERFORMING
MAINTENANCE JOBS
ALWAYS WEAR PROTECTIVE GLOVES AGAINST PHYSICAL AGENTS WHILE OPERATING
PNEUMATIC TOOL
ALWAYS WEAR SAFETY SHOES
Additional personal protective equipment to wear according to the values found in the environmental hygiene/risk analysis survey if
the values exceed the limits under current regulations.
WEAR ANTI-VIBRATION GLOVES WHILE OPERATING PNEUMATIC TOOL FOLLOWING A
SPECIALLY CONDUCTED SURVEY OF LEVEL OF DAILY EXPOSURE OF HAND-ARM SYSTEM TO
VIBRATION
PRODUCT SPECIFICATIONS
SOCKET DRIVE
BOLT CAPACITY (8.8)
BOLT CAPACITY (12.9)
FREE SPEED
MAXIMUM TORQUE
AIR INLET
MAXIMUM PRESSURE
MAXIMUM AIR CONSUMPTION
WEIGHT
LENGTH
HAMMER DEVICE TYPE
SOUND PRESSURE LEVEL
SOUND POWER LEVEL
VIBRATION LEVEL
KEY TO SYMBOLS
a: air inlet 1/4" GAS, cone-shaped
b: impact wrench trigger
c: ratchet reverse lever
d: min. – max torque selector
e: oil lubrication
f: greasing
INSTRUCTIONS FOR INSTALLING DEVICES
Air supply connection
For optimal use of the pneumatic tool, always keep to a maximum pressure of 6.2 bars, as measured at the tool inlet. Feed the
pneumatic tool with clean, condensate-free air (picture 2). Excessively high pressure or humidity in supply air results in shorter life for
the mechanical parts and may damage the tool.
1/2"
M14 - 21 mm
M12 - 19 mm
4700 rpm
240 Nm
1/4" GAS, cone-shaped
6.2 bars
190 l/min
2.1 kg
355 mm
SINGLE HAMMER
89.4 dB(A) (EN ISO 15744)
100.4 dB(A) (EN ISO 15744)
2
8.63 m/s (ISO 28927-2)