Phonic WM Serie Manual Del Usuario página 11

6. Bypass Button (WM400D-L and WM400D-
R only) – push this button to turn the digital
processing feature on and off.
7. Up and Down Buttons (WM400D-L and
WM400D-R only) – these buttons are used
to adjust the properties of various features
built-into the WM400D's. Pushing up or
down will initially simply allow users to ad-
just the channel that the transmitter is us-
ing. If you push both of these buttons at
the same time, it will jump to the next set-
ting that can be edited. You can then adjust
the properties by pushing the up and down
buttons. These settings will come in the fol-
lowing order:
Channel Settings :
CH 0 – CH 9, CH A – CH F
Delay Settings :
0.0 – 300.0 milliseconds
EQ Mode :
P – P30 (see the EQ table for
a full rundown on EQ presets)
Low Cut Filter :
L 20 (Hz) – L 2 (kHz)
High Cut Filter :
H 20 (kHz) – H 60 (Hz)
(High and low cut filters are adjusted in 1 Hz
increments; 10Hz increments above 1kHz)
8. Channel Selector (WM400-L and WM400-
R only) – adjusting this dial to one of the
preset channels allows the WM400 to
know which pre-set frequency to look for
the wireless information.
transmitter should be set to the identical
channel if transmission is to occur suc-
cessfully.
9. Power Indicator (WM400-L and WM400-R
only) – this LED indicator illuminates when
the WM400 receiver is powered.
10. Antenna – this is the WM400(D)'s anten-
na. Adjust it so it sits in a vertical position
when the device is in use (change the po-
sition if the wireless signal quality is poor).
Push the antenna in to release it before
adjusting its position.
WM SERIES
11. DC In and clip – plug DC end of the sup-
12. XLR Output – this jack accepts XLR con-
13. Fixing – Use this hole to secure the
The wireless
plied DC power adaptor (2V DC, 200mA)
into this jack, and the other end into a
suitable AC power source to allow the
WM400(D) to be powered. The accom-
panying clip ensures the DC head of the
power supply is kept securely in place.
nectors to feed the signal from the Wire-
less Receiver to the Speaker.
WM400(D) receiver into the mounting
socket of your speaker by using accom-
panying M6, M8 or M0 screws.
0

5
2
3
9
8