Quick Setup - Phonic WM Serie Manual Del Usuario

QUICK SETUP

Single Channel Setup
Users are able to wirelessly send a monau-
ral signal through the WM60 transmitter and
WM40-L/ WM400(D)-L receiver.
1. Plug the mixer's main output (with a line-
level signal) to either the XLR or  /4" input
of the WM60 transmitter.
2. Connect the provided DC power supply to
the WM60's and WM400(D)-L's power in-
put and an appropriate AC power source
and turn it on.
3. Adjust the channel on both the WM60 and
WM40-L/ WM400(D)-L so they are identi-
cal. If you wish to send and receive a signal
successfully, this is of utmost importance!
4. Adjust the WM60's and WM400(D)-L 's
antenna into a vertical position.
5. SYS1: Slide the WM40-L receiver into
the Performer's Wireless Module Recepta-
cle on the top right hand side of the speak-
er (right hand side, when facing the rear of
WM60
WIRELE SS T R ANSMIT TE R
S IG/CLI P
ON OFF
WM-SYS1: Single Channel Setup
6
WM40L is inside the slot of
Phonic Performer speaker
the speaker ) and screw it into place. Be
sure to move the module's
truding from the case) to either side of
the module. Ideally, the antennas should
be taped to the wall of the module slot.
SYS3: Attach the WM400(D)-L to the
speaker by H6, H8 screws or velcro strip.
Connect the WM400(D)-L's XLR output
to the input of your active speaker.
6. SYS1: Set the WIRELESS / WIRELESS
MIC switch on the rear panel of the Pho-
nic performer speaker to the "Wireless"
Position, and set the wireless volume
control to around 3 o'clock position.
SYS1/SYS3: Turn the WM60 on first ,
then the WM40-L or WM400(D)-L.
7. SYS1: Turn the WM60 on first, then the
Performer Speaker.
8. Provided you have a signal going out
of your mixer, and your Speaker is
turned on, the wireless transmission
should be working.
WM60
WIRELE SS T R ANSMIT TE R
S IG/CLI P
ON OFF
WM60
WM-SYS3: Single Channel Setup
antennas (pro-
Any active speaker
WM400-L
WM SERIES