Operating Determinations; Connections - EuroLite MINI-4 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATING DETERMINATIONS

This device is a lighting controller for controlling other devices like spots in discotheques, on stages etc. This
product is allowed to be operated with an alternating current of 230 V, 50 Hz and was designed for indoor
use only.
Do not shake the device. Avoid brute force when installing or operating the device.
When choosing the installation-spot, please make sure that the device is not exposed to extreme heat,
moisture or dust. There should not be any cables lying around. You endanger your own and the safety of
others!
This device must never be operated or stockpiled in sourroundings where splash water, rain, moisture or fog
may harm the device. Moisture or very high humidity can reduce the insulation and lead to mortal electrical
shocks. When using smoke machines, make sure that the device is never exposed to the direct smoke jet
and is installed in a distance of 0.5 meters between smoke machine and device. The room must only be
saturated with an amount of smoke that the visibility will always be more than 10 meters.
The ambient temperature must always be between -5° C and +45° C. Keep away from direct insulation
(particularly in cars) and heaters.
The relative humidity must not exceed 50 % with an ambient temperature of 45° C.
This device must only be operated in an altitude between -20 and 2000 m over NN.
The ambient contamination must never exceed level 1 and must not be conducting, only dry.
Never use the device during thunderstorms. Over voltage could destroy the device. Always disconnect the
device during thunderstorms.
Make sure that the area below the installation place is blocked when rigging, derigging or servicing the
fixture.
Never put any liquids on the device or close to it. Should any liquid enter the device nevertheless, disconnect
from mains immediately. Please let the device be checked by a qualified service technician before you
operate it again. Any damages caused by liquids having entered the device are not subject to warranty!
Operate the device only after having become familiarized with its functions. Do not permit operation by
persons not qualified for operating the device. Most damages are the result of unprofessional operation!
Please use the original packaging if the device is to be transported.
Inspection deadlines according to BGV-A2 for electrical resources must be complied with.
Please consider that unauthorized modifications on the device are forbidden due to safety reasons!
Never remove the serial barcode from the device as this would make the guarantee void.
If this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short-
circuit, burns, electric shock, etc.

CONNECTIONS

Installation
Install the device on a plane surface or install it in rack.
Rack-installation: The rack you use should be a Double-Door-Rack where you can open the frontpanel and
the rear panel. The rack should be provided with a cooling fan. When mounting the controller into the rack,
please make sure that there is enough space around the device so that the heated air can be passed on.
Steady overheating will damage your device.
You can fix the controller with four screws M6 in the rack.
12/27
00020529.DOC, Version 3.1

Publicidad

Tabla de contenido
loading

Tabla de contenido