Operating Determinations - EuroLite Foam 1200 Cannon Manual Del Usuario

This device falls under protection-class I. The power plug must only be plugged into a protection class I
outlet.
Always plug in the power plug last. Never let the power-cord come into contact with other cables! Handle the
power-cord and all connections with the mains with particular caution! Make sure that the available voltage is
not higher than stated on the rear panel. Make sure that the power-cord is never crimped or damaged by
sharp edges. Check the device and the power-cord from time to time.
Never drink fluid or use it on the inside or outside of a human body. If fluid gets in contact with skin or eyes,
rinse thoroughly with water. If it is necessary call a doctor immediately!
DANGER TO LIFE!
- Danger of suffocation for people or animals lying under the foam.
- Maintain sufficient sight in all directions.
- When operating the device, a sufficient number of safety personnel has to be present for supervising the
foam area so that any „disappearing" person will immediately be noticed. If in doubt, the safety personnel
have to limit the number of persons in the foam. The safety personnel must also verify that only such
persons are allowed into the foam who are fully clear.
- After switching off the foam machine, the safety personnel must remain in the foam area, until the foam has
completely disintegrated.
- There must be no obstacles in the foam area.
- The floor surface must be sufficiently anti-slippery. After the foam has disintegrated, the safety personnel
must verify that the floor surface is completely dry and not slippery.
Keep device upright. For overhead use (mounting height >100 cm), always fix the fixture with an appropriate
safety bond.
Always disconnect from the mains, when the device is not in use or before cleaning it. Only handle the
power-cord by the plug. Never pull out the plug by tugging the power-cord. Unused machines must be
disconnected from the mains. If the power plug or the power switch is not accessible, the device must be
disconnected via the mains.
Keep away children and amateurs! Never leave this device running unattended.

OPERATING DETERMINATIONS

This device is a special effect machine for creating foam effects. This product is only allowed to be operated
with an alternating voltage of 230 V, 50 Hz and was designed for indoor use only.
Do not shake the device. Avoid brute force when installing or operating the device. When choosing the
installation spot, please make sure that the device is not exposed to extreme heat, moisture or dust. Please
consider that liquid may be spilt during operation around the device. The resulting slippery surface can cause
accidents. There should not be any cables lying around. You endanger your own and the safety of others!
Before filling the device disconnect from mains. Never fill in any hot liquids.
Operate the device only after having familiarized with its functions. Do not permit operation by persons not
qualified for operating the device. Most damages are the result of unprofessional operation!
Store dry!
Always drain the tank and please use the original packaging if the device is to be transported.
Never remove the serial barcode from the device as this would make the guarantee void.
Please consider that unauthorized modifications on the device are forbidden due to safety reasons! If this
device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short-
circuit, burns, electric shock, etc.
9/24 00063281.DOC, Version 1.2